4/20/2023 0 Comments Ti connect version 1.6.1![]() The most significant improvement of this version is the doubling of the data rate to 17.28 Gbit/s in High Bit Rate 2 (HBR2) mode, which allows increased resolutions, higher refresh rates, and greater color depth, such as 3840 × 2160 at 60 Hz 10 bpc RGB. 1.2 ĭisplayPort version 1.2 was introduced on 7 January 2010. The DisplayPort 1.1a standard can be downloaded for free from the VESA website. It also includes HDCP in addition to DisplayPort Content Protection (DPCP). DisplayPort 1.1 allows devices to implement alternative link layers such as fiber optic, allowing a much longer reach between source and display without signal degradation, although alternative implementations are not standardized. DisplayPort cables up to 2 meters in length are required to support the full 10.8 Gbit/s bandwidth. ĭisplayPort 1.0–1.1a allow a maximum bandwidth of 10.8 Gbit/s (8.64 Gbit/s data rate) over a standard 4-lane main link. Version 1.1 was ratified on 2 April 2007, and version 1.1a was ratified on 11 January 2008. The first version, 1.0, was approved by VESA on. 11.1 Support for DisplayPort Alternate Mode over USB-C.7 Advantages over DVI, VGA and FPD-Link.4.3 Refresh frequency limits for HDR video.4.2 Refresh frequency limits for standard video.4.1 Refresh frequency limits for common resolutions.4 Resolution and refresh frequency limits.3.1.2 Cable bandwidth and certifications.3.1.1 Compatibility and feature support.Active VGA adapters are powered directly by the DisplayPort connector, while active dual-link DVI adapters typically rely on an external power source such as USB. For analog VGA/ YPbPr and dual-link DVI, a powered active adapter is required for compatibility and does not rely on dual mode. ![]() However, dual-mode DisplayPort ports are designed to transmit a single-link DVI or HDMI protocol ( TMDS) across the interface through the use of an external passive adapter, enabling compatibility mode and converting the signal from 3.3 to 5 volts. ![]() The interface uses an LVDS signal protocol that is not compatible with DVI or HDMI. The interface is also capable of carrying bidirectional USB signals. A bidirectional, half-duplex auxiliary channel carries device management and device control data for the Main Link, such as VESA EDID, MCCS, and DPMS standards. The video signal path can range from six to sixteen bits per color channel, and the audio path can have up to eight channels of 24-bit, 192 kHz uncompressed PCM audio. ĭisplayPort can be used to transmit audio and video simultaneously, although each can be transmitted without the other. The use of data packets also makes it extensible, meaning more features can be added over time without significant changes to the physical interface. Unlike legacy standards that transmit a clock signal with each output, its protocol is based on small data packets known as micro packets, which can embed the clock signal in the data stream, allowing higher resolution using fewer pins. It permits the use of internal and external display connections. It is the first display interface to rely on packetized data transmission, a form of digital communication found in technologies such as Ethernet, USB, and PCI Express. It is backward compatible with other interfaces, such as HDMI and DVI, through the use of either active or passive adapters. ĭisplayPort was designed to replace VGA, FPD-Link, and Digital Visual Interface (DVI). It can also carry audio, USB, and other forms of data. It is primarily used to connect a video source to a display device such as a computer monitor. ![]() and 30/20 pins for internal connections between graphics engines and built-in flat panels.ġ.62, 2.7, 5.4, 8.1, or 20 Gbit/s data rate per lane 1, 2, or 4 lanes (effective total 5.184, 8.64, 17.28, 25.92, or 77.37 Gbit/s for 4-lane link) 2 or 720 Mbit/s (effectively 1 or 576 Mbit/s) for the auxiliary channel.Ī DisplayPort port (top right) near an Ethernet port and a USB portĭisplayPort ( DP) is a digital display interface developed by a consortium of PC and chip manufacturers and standardized by the Video Electronics Standards Association (VESA). Optional, maximum resolution limited by available bandwidthĢ0 pins for external connectors on desktops, notebooks, graphics cards, monitors, etc. Optional 1–8 channels, 16 or 24-bit linear PCM 32–192 kHz sampling rate maximum bitrate 36,864 kbit/s (4,608 kB/s)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |